Balboa error code sn

Refill if necessary. Make sure the pumps have been primed. Press any button to reset. Spa Control Trouble- Shooting. Why does the soldered in fuse located on. Why does the control panel display " OH"? Why isn' t the system maintaining the set. The " SnS", " Sn", or " SENSOR SYNC" Fault has occurred for more than 1 hour, indicating one or both Sensors are several degrees off, and Spa Functions are. Cause: There is an " Over Heated Heater" ( OHH or HH) Condition. One of the Water Temp Sensors has detected 118° F ( 47. Troubleshooting Balboa Legacy Control Systems ( Non M7). This video will show what " Sn1", " Sn3", " Sn" or " Heat Status LED" on a spa control.

  • Wii error code 20100 mw3 weapons
  • Skyrim error code 2343
  • Ultram lto 5 error code 67
  • 99 error code asus zenbook


  • Video:Code error balboa

    Code balboa error

    Balboa ( used by Belize Spas and many other hot tubs). pd = Power supply, unit running on battery backup. OH = Sensors reading° F. balboa- error- code- Sn- Sn1- Sn2- Sn3- SnS- Continuing in my little series on spa and hot tub error codes or trouble codes, today we take a look at Sensor Errors. Click on any linkable error code below for more information. Please note that the Balboa Error Codes cover all circuit board manufactured by Balboa including. Do not use spa when temperature is flashing or the OH message is displayed. Cyclic Redundancy Code" ( CrC) Checksum Error. Display to see if the " OHS", " OH", or " SPA TEMP LMT" Spa Water Overheat Error Message has Cleared. Then power the system back up, if the error code goes away, the problem was either a. OH, OHH, OHS, OHt, HL, HiLi, Sn2, Sn3, tS, Ht, Blinking Lights.

    FINAL NOTE: Balboa M7 systems have the Temperature Sensor as well as the Hi Limit.